INLINE DIVERTER INSTALLATION

To assemble the Inline diverter simply slide the elbow on one leg of the diverter and the zig-zag elbow on the other leg and secure with self-taping screws provided.

The downspout coming into the top of the diverter should be cut so it slides into the diverter 1 inch and secured with screws provided. (see crimping instructions below)

The bottom of the zig-zag elbow needs to fit down into the downspout by 1 inch and secured with screws provided. (No crimping is required, the Zig-Zag comes pre-crimped.

You can alter the sides you choose to place the barrel by switching components of the diverter.

Step one:
Using Needle nose pliers grip right hand side of downspout corner and twist counter clockwise, creating a fold.

Step two:
Grip left of fold and twist clockwise (on same corner as Step one)

Step three:
Repeat on all four corners.

These crimps will downsize the end of downspout so it will fit into the top of the diverter.